Connectors

ODU Electrical contacts

ODU SPRINGTAC®

ODU Einzelkontakte

The no contact principle transfers signals and power more reliably than the patented ODU SPRINGTAC® system. Thanks to the individually suspended springwires, even in small diameters this contact offers an extremely high number of contact surfaces. Up to 15 springs are mounted into even the smallest design with a 0.76mm contact diameter. Each spring enters into contact with the pin – and it does so reliably: with an extremely high number of mating cycles and stable low contact resistances.

ODU LAMTAC®

ODU LAMTAC

Equipped with a stamped lamella strip, the ODU LAMTAC® achieves a high level of contact stability with very low wear. At 10,000+ mating cycles, this contact features enormous economic efficiency.

Features:

  • More than 10,000 mating cycles
  • Low contact resistances
  • High vibration resistance
  • Economical construction
  • High current-carrying capacity

 

ODU SPRINGTAC® Flatsocket

ODU SPRINGTAC

Connections with flat or rectangular contacts are used primarily in motor vehicle electronic systems, but also in other areas. Because these connections are only demated during servicing, a high number of mating cycles is not a key requirement. However, as the complete inspection of these electronic units is done over these flat and rectangular pins, the service life and material durability of the mating component - the test unit - is enormously important.

ODU TURNTAC®

The universal ODU TURNTAC® contact system combines the very best contact properties and high quality with economic prices. It has stood the test of even the toughest application areas. The contact principle can be even used in dimensions as tiny as 0.3 mm in diameter. Depending on the variety of slotted contact, the connector systems offers two or four contact areas.